Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterTrusted Gate Repair for Missouri City Homeowners
A gate that won’t open, drags across the driveway, or groans like it’s about to give up isn’t something to put off. In Missouri City, where swing gates and slide gates sit exposed to Gulf Coast humidity and clay soil that shifts with every wet-dry cycle, small gate problems turn into structural ones faster than homeowners expect. Vance Gate Repair has repaired and installed more than 22,000 gates since 2014. We work on electric and automatic gates, hinges, posts, locks, and welded steel, and we hand you a written price before any tool comes off the truck. If your gate is down right now, call (346) 253-1761. A live person answers, day or night.
What Our Gate Repair Service Includes
Electric Gate Repair
Electric Gate Repair covers the components that carry power and signal through the gate: wiring, circuit boards, photo-eyes, limit switches, and the transformer that feeds everything. You need it when the gate stops responding to the remote, opens halfway and reverses, or trips a breaker every time it cycles. We diagnose the fault in the field and leave you a written record of what was found, what was set, and what was replaced before we leave the property.
Automatic Gate Repair
Automatic Gate Repair focuses on the operator, the motor that physically moves the gate leaf, and the safety devices around it: edge sensors, loops, and the receiver that talks to your remote or keypad. You know it’s time when the motor hums but nothing moves, the gate slams at the end of travel, or the keypad stops accepting codes. We service nine major brands, including DoorKing and Linear, and every job ends with a photographed record of the adjustment or part installed.
Hinge & Post Repair
Hinge & Post Repair addresses the load-bearing steel that carries the entire weight of the gate. In Missouri City, especially in neighborhoods like Sienna and Lake Olympia, the clay soil expands and contracts enough to shift posts out of plumb, which then stresses the hinge barrels and welds. We realign or reset posts as needed, replace worn hinge pins and barrels, and weld cracked brackets back to full load capacity.
Gate Realignment
Gate Realignment is the careful job of getting a dragging or sagging gate back to level so it travels cleanly and the operator isn’t fighting its own weight. A gate that scrapes the driveway or won’t latch is usually a combination of a shifted post, a stretched hinge, or a worn wheel on a slide gate. In the New Territory area we see this constantly: the ground moves, the gate settles, and the wheel assembly takes the abuse.
Lock Repair
Lock repair covers mechanical gate locks, solenoid locks tied into the access system, and the strike plates that catch them. A lock that’s stiff in the morning and loosens through the day is often swollen from humidity, and forcing it just bends the key or breaks the thumb latch. We replace locks, adjust strike alignment, and when the lock is tied into an access control panel, we trace the wiring so both the lock and the release signal work as one system.
Weld & Rust Repair
Weld and rust repair deals with the steel itself: cracked pickets, rusted-through bottom rails, broken hinge brackets, and gate frames splitting at the corners. Near the Gulf, powder coat hides rust until the metal underneath has thinned past a safe point. We cut out the compromised section, weld in new steel, and leave you with a photo log of every inch of the repair so you can see exactly what was done.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service for Gate Repair
We’ve worked on a lot of Viking operators over the years. Viking swing and slide operators are common on larger residential gates in Fort Bend County, and the fixes we see most involve limit-switch drift and worn drive gears. We carry the common OEM parts for Viking units and we know how to set their travel limits without overrunning the stops.
DoorKing is another brand we know well. DoorKing operators are workhorses, but their circuit boards are sensitive to power surges, which we get during thunderstorm season. A board that’s taking a hit won’t always show it visually. We test with a multimeter, identify the failed component, and replace only what failed, which keeps the cost down compared to swapping the whole operator. Whether you have a Linear operator, a Ghost Controls unit, or any other make on your gate, we can diagnose and repair it. We don’t steer you toward replacement when a repair is the right fix.
BeforeAfterSigns You Need Gate Repair Right Now
- The gate reverses before it closes. This is usually a photo-eye out of alignment or an edge sensor sending a false obstruction signal. If you wait, the safety system may get bypassed the wrong way, and then you have a gate that pins a car or a person.
- The motor runs but the gate barely moves. That’s a slipping drive gear, a broken chain, or a shear pin that’s already let go. The motor is working harder than it should, and every cycle is wearing it out faster.
- The gate sounds like metal scraping metal. Scraping means a wheel bearing, hinge, or roller is worn past lubrication. Once steel touches steel under load, the surface scores, and the part becomes unrepairable in a few weeks.
- The gate sits crooked in its opening. A visible drop at the free end says a hinge or post is failing. Ignored, the weight transfer can tear the gate frame apart at the welds.
- The keypad or remote works sometimes, but not always. Intermittent operation points to a failing receiver, a loose antenna connection, or a control board that’s heating up and faulting. These are the calls that leave you stuck outside at the worst time.
Our Gate Repair Process - Step by Step
- 1
You call, a technician answers questions. We ask what the gate is doing, what brand the operator is, and when the problem started. We write down what you tell us so when the technician arrives, the job record already has your description in it.
- 2
We arrive with a name and photo provided beforehand. Every technician is background-checked and uniformed. You get notice of who’s coming to your property before they pull into the driveway.
- 3
We diagnose and hand you a written price. Before any work starts, you get a written scope: the fault, the fix, and the flat price. This is Haven Standard Clause 1, and it’s not negotiable on our end. You approve it in writing first.
- 4
We complete the repair and photograph everything. Limit-switch settings, wire terminations, hinge welds, the new part’s serial number. You get a photo log of every adjustment and a written record of the part number installed. Clause 4: Evidence on every job.
- 5
We walk you through the gate before we leave. We cycle the gate with you standing there, show you the photographs, and answer any questions. You know what was found, what was changed, and what it cost. Then we leave the driveway clean.
How Much Does Gate Repair Cost in Missouri City?
Gate repair in Missouri City typically runs between $125 and $850, depending on the fault. A photo-eye realignment or limit-switch adjustment is usually $125 to $225. Replacing a gate lock assembly runs $180 to $320. A swing-gate motor or control board replacement lands between $450 and $850, depending on the brand and whether the arm bracket is still intact. Slide-gate wheel and roller replacement is usually $300 to $500 for a single gate.
What moves the price? The operator brand matters because OEM parts for DoorKing and Viking cost more than universal parts, and we tell you which one we’re quoting. The condition of the surrounding structure matters too: a hinge repair that becomes a post reset costs more because the post has to be dug, plumbed, and re-set in concrete. Gate weight and length also affect parts pricing on heavy steel gates in neighborhoods like Pecan Grove.
How to avoid overpaying: get the problem diagnosed before any part gets ordered. We don’t replace parts on a guess, and our written quote shows the exact part number and its cost. If you have a written estimate from another company, bring it to us. We’ll review it at no cost as a free second opinion. And every estimate from Vance Gate Repair Missouri City is free, written, and valid because the price is agreed before any work starts. Call (346) 253-1761 and get a number in hand.
Gate Repair Near Missouri City - Our Service Area
Vance Gate Repair serves Missouri City and the surrounding Fort Bend County communities, including Sugar Land, Stafford, Fresno, Greatwood, New Territory, Four Corners, Pecan Grove, Mission Bend, Manvel, Bellaire, and West University Place. Most repair calls in Missouri City are reached the same day, and emergency calls are dispatched as soon as a technician is free. If you’re in Stafford, see our Gate Repair in Stafford page for local details. If you’re further out, our Gate Repair in Fresno page covers that area. And for the full scope of what we do, start at our home page or the Gate Repair in Missouri City hub.
Serving Missouri City, TX - Our Local Coverage Area
We’re based in the Missouri City area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
Frequently Asked Questions - Gate Repair in Missouri City
Gate repair is the work of restoring a driveway or pedestrian gate to safe, reliable operation when something on it fails. That includes the physical gate structure, the hinges and posts, the lock, the electric wiring, and the automatic operator that moves it. In Missouri City we repair all of it, and we document what was done with photos and a written record on every visit.
Most repairs take between one and two and a half hours on site. Simple adjustments like a limit switch or photo-eye take under an hour. A post reset or a weld repair that needs to cool and be painted can take half a day. We’ll give you a realistic time frame when we hand you the written quote, and we stick to it.
Most gate repairs in Missouri City fall between $125 and $850. Small fixes like limit-switch adjustments or sensor realignment run $125 to $225, while operator or circuit board replacements run $450 to $850. Your price is written down and handed to you before any work starts, so there’s no surprise at the end. Call (346) 253-1761 for an exact quote on your gate.
Yes. We service DoorKing, Viking, Linear, Ghost Controls, and several other major brands. We carry common OEM parts for DoorKing and Viking operators, and we know their control boards and limit systems well. We don’t push a replacement when repairing the existing operator is the right call.
In most cases, yes. A live person answers the phone 24 hours a day, seven days a week, and we dispatch same-day in Missouri City whenever a technician is available. If your gate is stuck open or stuck closed, call (346) 253-1761 and we’ll tell you directly when someone can be there.
Every repair carries our 365-Day Done Right Promise. If the repair is not right within one full year, we make it right at no additional charge. No argument, no fee, no expiration date inside that window. If a part we installed fails inside that year, we replace it and stand behind the labor too.
Clear the area around the gate so the technician can reach the hinges, posts, and operator without moving your vehicles or landscaping equipment. If you have the original remote or keypad codes, have them available for testing after the repair. You don’t need to do anything to the gate itself. Just call (346) 253-1761, tell us what it’s doing, and we’ll handle the rest.
Schedule Your Gate Repair Service in Missouri City Today
Call (346) 253-1761 and tell us what your gate is doing. A live person answers 24/7, no voicemail loop. We’ll dispatch a background-checked, uniformed technician to your Missouri City home, diagnose the problem on site, and hand you a written price before any work begins. Free estimate, no obligation, and every job leaves with a photographed record. Gate Repair in Missouri City is one call away.
Written by Adrian Vance, Owner at Vance Gate Repair Missouri City, serving Missouri City since 2014.